Removal Procedure
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Raise and support the vehicle. Lifting and Jacking the Vehicle .
- Remove the front tire and wheel assembly. Tire and Wheel Removal and Installation
- Clean all dirt and foreign material from the brake hose ends and the brake pipe fitting.
Brake Pressure Modulator Valve Front Brake Pipe Fitting (1) @ Front Brake Hose (3) - Remove
- Cap the brake pipe fitting to prevent brake fluid loss and contamination.
- Front Brake Hose Retainer (2) - Remove
Front Brake Hose Bracket Nut (1) - Remove
Front Brake Hose Fitting Bolt (1) @ Front Brake Caliper - Remove
- Front Brake Hose (2) @ Front Brake Caliper - Remove
- Front Brake Hose Washer (3) - Remove and DISCARD [2x]
These washers may be stuck to the brake caliper and/or the brake hose end.