Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

With a flat bladed plastic trim tool, start at the front and work your way back to release the clips.
Instrument Panel Outer Trim Cover - Left Side (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Hood Primary Latch Release Cable Handle (1) @ Instrument Panel Knee Bolster - Remove
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Knee Bolster Bolt (1) - Remove [3x]
Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed tool, release instrument panel knee bolster (1).
Instrument Panel Knee Bolster (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Switch Trim Plate Bolt (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed tool, release instrument panel switch trim plate (1).
Instrument Panel Switch Trim Plate (1) - Remove
Disconnect the electrical connector.
Extend the steering column to its furthest point to allow the instrument panel steering column upper trim cover to clear the instrument panel.
Courtesy of GENERAL MOTORS COMPANY

With a flat bladed plastic trim tool, release the retaining clips.
Instrument Panel Cluster Trim Plate (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Release the plastic retaining tabs.
Instrument Panel Cluster Trim Plate Applique (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Trim Plate Strap Bolt (1) - Remove [4x]
Instrument Panel Instrument Cluster Hood (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

With a flat bladed plastic trim tool, release the retaining clips.
Instrument Panel Bolt Cover - Left Side (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

With a flat bladed plastic trim tool, release the retaining clips.
Instrument Panel Bolt Cover - Right Side (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Instrument Cluster Bolt (1) - Remove [4x]
Courtesy of GENERAL MOTORS COMPANY

Release the retaining tab.
Instrument Cluster (1) - Remove
Disconnect the electrical connector.
Courtesy of GENERAL MOTORS COMPANY

Using a small plastic trim tool, separate the instrument panel steering column upper trim cover (1) from the instrument panel steering column lower trim cover.
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Trim Plate Applique Bolt (1) - Remove
Release the retainers with a suitable plastic trim tool.
Instrument Panel Trim Plate Applique - Left Side (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed tool, release instrument panel center trim plate applique (1).
Instrument Panel Center Trim Plate Applique (1) - Remove
Disconnect the electrical connector.
Courtesy of GENERAL MOTORS COMPANY

Heater and Air Conditioning User Interface Control Bolt (1) - Remove [2x]
Disconnect the electrical connector.
Heater and Air Conditioning User Interface Control (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Trim Plate Applique Bolt (1) - Remove [4x]
Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed tool, release instrument panel trim plate applique (1).
Instrument Panel Trim Plate Applique - Right Side (1) - Remove
Disconnect the electrical connector.
Courtesy of GENERAL MOTORS COMPANY

{If equipped} Remove the ignition and start switch:
1. Release the retaining tabs.
2. Ignition and Start Switch (1) - Remove