Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

With a flat bladed plastic trim tool, start at the front and work your way back to release the clips.
Instrument Panel Outer Trim Cover - Left Side (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Hood Primary Latch Release Cable Handle (1) @ Instrument Panel Knee Bolster - Remove
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Knee Bolster Bolt (1) - Remove [3x]
Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed tool, release instrument panel knee bolster (1).
Instrument Panel Knee Bolster (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Switch Trim Plate Bolt (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed tool, release instrument panel switch trim plate (1).
Instrument Panel Switch Trim Plate (1) - Remove
Disconnect the electrical connector.
Extend the steering column to its furthest point to allow the instrument panel steering column upper trim cover to clear the instrument panel.
Courtesy of GENERAL MOTORS COMPANY

Using a small plastic trim tool, separate the instrument panel steering column upper trim cover (1) from the instrument panel steering column lower trim cover.
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Trim Plate Applique Bolt (1) - Remove
Release the retainers with a suitable plastic trim tool.
Instrument Panel Trim Plate Applique - Left Side (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Steering Column Upper Trim Cover (1) @ Instrument Panel Trim Plate Applique - Left Side (2) - Remove