Removal Procedure
- Turn the ignition switch to the On position, engine Off.
- Apply the parking brake.
- Place the transmission control in the Neutral position.
- Turn the ignition switch to the Off position.
Using a trim tool, release the retainers (arrows) from the front floor console.
- Release the rear locating tab (1) from the front floor console.
- Pull the transmission control lever boot bezel up to gain access to the electrical connector
Electrical Connector (1) - Disconnect [2x]
With a firm grip on the transmission control lever knob (1), slightly twist the transmission control lever knob side to side, then firmly pull up on the transmission control lever knob. This will unseat the locking circlip.
- Transmission Control Lever Knob (1) @ Transmission Control Lever - Remove
Using a suitable plastic trim tool, release the retaining tabs.
- Disconnect the electrical connector.
- Front Floor Console Trim Plate (1) - Remove
Release the retaining tabs.
- Floor Console Accessory Function Switch (1) - Remove