Installation Procedure
Floor Console Accessory Function Switch (1) - Install
- Secure the retaining tabs.
Connect the electrical connector.
- Front Floor Console Trim Plate (1) - Install
Transmission Control Lever Knob (1) @ Transmission Control Lever - Install
Electrical Connector (1) - Connect [2x]
Insert the rear locating tab (1) into the front floor console.
- Seat the retainers (arrows) of the bezel into the front floor console.
- Turn the ignition switch to On position, engine Off.
- Place transmission control in the Park position.
- Un-apply the parking brake.
- Turn the ignition switch to the Off position.
NOTE:
Pull up on the shift knob after installation, to ensure the knob clip is locked in place.