Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

Front Floor Console (1) - Remove - Front Floor Console Removal and Installation
Courtesy of GENERAL MOTORS COMPANY

Open the front floor console armrest.
Front Floor Console Rear Trim Panel Bolt (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Front Floor Console Wiring Harness Retainer (2) - Remove
Disconnect the electrical connector.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
To make it easier to separate, turn the console upside down and slide the clips from the bottom of the console

Using a flat-bladed plastic trim tool, release the retaining clips.
Front Floor Console Rear Trim Panel (1) - Remove
Disconnect the electrical connector.
Courtesy of GENERAL MOTORS COMPANY

Air Inlet Grille Panel Retainer (1) - Remove [2x]
Courtesy of GENERAL MOTORS COMPANY

Air Inlet Grille Panel Retainer (1) - Remove [2x]
Courtesy of GENERAL MOTORS COMPANY

Front Floor Console Rear Air Front Duct (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Front Floor Console Bracket Bolt (1) - Remove [2x]
Front Floor Console Bracket (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Disconnect the electrical connector.
Theft Deterrent Module Bolt (1) - Remove [2x]
Theft Deterrent Module (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Front Floor Console Compartment Bolt (1) - Remove [10x]
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Quantity of retainers may vary based on option content.

Disconnect the wiring harness retainers. (1)
Remove the wiring harness. (2)
Courtesy of GENERAL MOTORS COMPANY

Front Floor Console Compartment (1) @ Front Floor Lower Console (2) - Remove
Transfer components as necessary.