Removal Procedure
Front Floor Console (1) - Remove - Front Floor Console Removal and Installation
Open the front floor console armrest.
- Front Floor Console Rear Trim Panel Bolt (1) - Remove
Front Floor Console Wiring Harness Retainer (2) - Remove
- Disconnect the electrical connector.
- NOTE:
To make it easier to separate, turn the console upside down and slide the clips from the bottom of the console
Using a suitable plastic trim tool, release the retaining tabs.
- Front Floor Console Rear Trim Panel (1) - Remove
- Disconnect the electrical connector.
Air Inlet Grille Panel Retainer (1) - Remove [2x]
Air Inlet Grille Panel Retainer (1) - Remove [2x]
Front Floor Console Rear Air Front Duct (1) - Remove
Front Floor Console Bracket Bolt (1) - Remove [2x]
- Front Floor Console Bracket (2) - Remove