Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

Front Floor Console (1) - Remove - Front Floor Console Removal and Installation
Courtesy of GENERAL MOTORS COMPANY

Open the front floor console armrest.
Front Floor Console Rear Trim Panel Bolt (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Front Floor Console Wiring Harness Retainer (2) - Remove
Disconnect the electrical connector.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
To make it easier to separate, turn the console upside down and slide the clips from the bottom of the console

Using a suitable plastic trim tool, release the retaining tabs.
Front Floor Console Rear Trim Panel (1) - Remove
Disconnect the electrical connector.
Courtesy of GENERAL MOTORS COMPANY

Use a suitable tool to release the front floor console armrest hinge clip (1) from the pivot pin (2).
Front Floor Console Armrest Pivot Pin (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Front Floor Console Armrest (1) - Remove
Inspect the springs. Transfer if not worn or damaged.