LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2024 >> Traverse LS, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Displays And Gauges >> Diagnostic Information and Procedures >> Speedometer and / or Odometer Malfunction >> Circuit / System Testing

Circuit / System Testing

NOTE:

The Service Programming System may not be able to properly read or recover the vehicle odometer value, if the following occurs:

  • Component is from a different vehicle:
  • Control Module - 2 or more = Not Original Equipment
  • Control Module - Configuration = Incorrect

Circuit / System Testing A 

  1. Ignition - On / Vehicle - In Service Mode
  2. Verify the scan tool parameter: Vehicle Identification Number (VIN) @ Body Control Module = Vehicle Identification Number (VIN) - Actual
    • If not the specified state 

      Program the control module: K9 Body Control Module

    • Go to next step: If the specified state 
  3. Verify the scan tool parameter: Vehicle Identification Number (VIN) @ A11 Radio = Vehicle Identification Number (VIN) - Actual
    • If not the specified state 

      Program the control module: A11 Radio

    • Go to next step: If the specified state 
  4. Verify the component works as specified: Odometer = Correct
    • If the parameter displays the following: - - 

      Replace the component: A11 Radio

    • Go to next step: If the component works as specified 
  5. All OK.

Circuit / System Testing B 

  1. Ignition - On / Vehicle - In Service Mode
  2. Verify the scan tool parameter: Odometer Lock Status = Active
    • If the parameter displays the following: Inactive 

      Refer to: Circuit / System Testing A

    • Go to next step: If the parameter displays the following: Active 
  3. Verify the scan tool parameter: Vehicle Identification Number (VIN) @ A11 Radio = Vehicle Identification Number (VIN) - Actual
    • If not the specified state 

      Program the control module: A11 Radio

    • Go to next step: If the specified state 
  4. Perform the SPS function: Module Setup - K9 Body Control Module
  5. Verify the component works as specified: Odometer = Correct
    • If the parameter displays the following: - - 

      Replace the component: A11 Radio

    • Go to next step: If the component works as specified 
  6. All OK.
scientia non olet · About LEMON Manuals