Installation Procedure
If NEW threaded components are being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded components are reused, prepare the threaded components using the following steps:
- Remove any loose cured adhesive from the external threads of the components using a lint free cloth.
- Thread the cleaned components into the internal mating threads and remove to loosen trapped cured adhesive.
- Remove loose debris from internal and external threads using compressed air.
- Apply liquid thread locking adhesive in a strip along half of the length of the external threads, starting at the tip, just prior to installation. Adhesives, Fluids, Lubricants, and Sealers
- Transfer Case Oil Drain Plug (1) - Install and tighten - Fastener Specifications
Transfer Case Oil Fill Plug (1) - Remove
- Fill the transfer case with fluid.
If NEW threaded components are being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded components are reused, prepare the threaded components using the following steps:
- Remove any loose cured adhesive from the external threads of the components using a lint free cloth.
- Thread the cleaned components into the internal mating threads and remove to loosen trapped cured adhesive.
- Remove loose debris from internal and external threads using compressed air.
- Apply liquid thread locking adhesive in a strip along half of the length of the external threads, starting at the tip, just prior to installation. Adhesives, Fluids, Lubricants, and Sealers
- Transfer Case Oil Fill Plug (1) - Install and tighten - Fastener Specifications
- Remove the drain pan.
- {If equipped} Transfer Case Skid Shield (2) - Install - Transfer Case Skid Shield Replacement
- Remove the support and lower the vehicle.
CAUTION:
Refer to Component Fastener Tightening Caution .