Circuit/System Verification
- Ignition - On/Vehicle - In Service Mode
- Verify DTC C10BA, C116F, C118D, C119C is not set.
- If a related DTC is set
Refer to:DTC C10BA, C116F, C118D, or C119C
- Go to next step: If a related DTC is not set
- If a related DTC is set
- Verify a condition does not exist with the component:Front Axle
Refer to:Four-Wheel Drive Does Not Engage
- If a condition exists
Repair or replace as necessary
- Go to next step: If no condition exists
- If a condition exists
- Test or replace the component:M26 Front Drive Axle Actuator