Removal Procedure
- Front Wheelhouse Liner- Right Side - Remove - Front Wheelhouse Liner Replacement
Catalytic Converter Brace Bracket Nut (1) - Remove [2x]
- Wiring Harness Retainer (2) - Remove
- Raise the vehicle.
Using a suitable tool, remove the position 2 nitrogen oxides sensor (1) from the nitrogen oxides catalytic converter.
Using a suitable tool, remove the position 3 nitrogen oxides sensor (1) from the nitrogen oxides catalytic converter.
Using a suitable tool, remove the exhaust particulate sensor (1) from the nitrogen oxides catalytic converter.
Exhaust Pipe Clamp (1) - Loosen
Exhaust Front Pipe Nut (1) - Remove [2x]
Catalytic Converter Brace Bracket (1) - Remove
Exhaust Front Pipe Nut (1) - Remove [2x]
Nitrogen Oxides Catalytic Converter (1) - Remove
- Exhaust System Front Gasket (2) - Remove and DISCARD
- Support the transmission with a suitable jack.
Remove the wiring harness (2) with automatic level control air supply line (3) from the retainers (1) and reposition as necessary.
Remove the chassis wire harness clip (1) from the automatic level control air supply reservoir.
Remove the 3 automatic level control air compressor bolts (1).
- Reposition and support the automatic level control air supply reservoir (2) out of the way of the transmission support crossmember.
Transmission Mount Nut (1) - Remove
- Transmission Support Crossmember Nut (2) - Remove [4x]
- Transmission Support Crossmember Bolt (3) - Remove [4x]
Transmission Support Crossmember (1) - Remove
- Lower the transmission enough to gain access to the transmission vent hose.
Remove the 2 transmission vent hose retainers (1).
- Remove the transmission vent hose. (2)