Installation Procedure
Transmission Mount (2) - Install
- If NEW threaded components are being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded components are reused, prepare the threaded components using the following steps:
- Remove any loose cured adhesive from the external threads of the components using a lint free cloth.
- Thread the cleaned components into the internal mating threads and remove to loosen trapped cured adhesive.
- Apply thread locking adhesive to the external threads of the components. Adhesives, Fluids, Lubricants, and Sealers
- Ensure there are no gaps in the thread locking adhesive once applied to the component.
- Transmission Mount Bolt (1) - Install and tighten [2x] - Fastener Specifications
Transmission Support Crossmember (1) - Install
Transmission Support Crossmember Bolt (3) - Install [4x]
- Transmission Support Crossmember Nut (2) - Install and tighten [4x] - Fastener Specifications
- Transmission Mount Nut (1) - Install and tighten [2x] - Fastener Specifications
- Remove the transmission jack.
If equipped, position the wiring harness (2) as necessary then install the harness into the 3 wiring harness retainers (1).
{If equipped} Transfer Case Skid Shield (2) - Install
- {If equipped} Transfer Case Skid Shield Bolt (1) - Install and tighten [3x] - Fastener Specifications
- Lower the vehicle.
CAUTION:
Refer to Fastener Caution