Installation Procedure
Transmission Mount (2) - Install
- If NEW threaded components are being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded components are reused, prepare the threaded components using the following steps:
- Remove any loose cured adhesive from the external threads of the components using a lint free cloth.
- Thread the cleaned components into the internal mating threads and remove to loosen trapped cured adhesive.
- Apply thread locking adhesive to the external threads of the components. Adhesives, Fluids, Lubricants, and Sealers
- Ensure there are no gaps in the thread locking adhesive once applied to the component.
- Transmission Mount Bolt (1) - Install and tighten [2x] - Fastener Specifications
Transmission Support Crossmember (1) - Install
Transmission Support Crossmember Bolt (3) - Install [4x]
- Transmission Support Crossmember Nut (2) - Install and tighten [4x] - Fastener Specifications
- Transmission Mount Nut (1) - Install and tighten [2x] - Fastener Specifications
- Remove the transmission jack.
If equipped, position the wiring harness (2) as necessary then install the harness into the 3 wiring harness retainers (1).
Automatic Level Control Air Supply Reservoir (2) - Install
- Install the 3 automatic level control air compressor bolts (1) and tighten. Fastener Specifications
Install the chassis wire harness clip (1) to the automatic level control air supply reservoir.
Install the air line (2) and clip the 2 air line retainers (1).
{If equipped} Transfer Case Skid Shield (2) - Install
- {If equipped} Transfer Case Skid Shield Bolt (1) - Install and tighten [3x] - Fastener Specifications
- Lower the vehicle.
CAUTION:
Refer to Fastener Caution