Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Transmission Converter Cover-Right Side (2) - Install

CAUTION:

Refer to Fastener Caution .

Transmission Converter Cover Bolt (1) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Starter (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Electrical Connector (3) - Connect
Protective Sleeve (4) - Install
Starter Solenoid Cable (1) - Install
Starter Solenoid Cable Nut (2) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Starter Mounting Bolt (1) - Install and tighten [2x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Starter Solenoid Cable (2) - Install
Battery Negative Cable Ground Bolt (1) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Catalytic converter removed for graphic clarity.

Starter Heat Shield (2) - Install
Starter Heat Shield Bolt (1) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Starter Heat Shield Bolt (1) - Install and tighten [2x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

{with RC1} Install the underbody skid shield:
1. Underbody Skid Shield (3) - Install
2. Underbody Splash Shield Bolt (2) - Install and tighten [2x] - Fastener Specifications
3. Underbody Skid Shield Bolt (1) - Install and tighten [2x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

{without RC1} Install the underbody skid shield:
1. Underbody Skid Shield (2) - Install
2. Underbody Skid Shield Bolt (1) - Install and tighten [4x] - Fastener Specifications
Lower the vehicle.
Connect the negative battery cable. Battery Negative Cable Disconnection and Connection (9C1/5W4) , or Battery Negative Cable Disconnection and Connection (KL9)