Removal Procedure
Using a flat-bladed plastic trim tool, release the retaining clips.
- Instrument Panel Fuse Block Access Hole Cover (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Instrument Panel Trim Plate Applique (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Instrument Panel Center Trim Plate Applique (1) - Remove
Instrument Panel Upper Trim Panel Bolt (1) - Remove [6x]
- Using a flat-bladed plastic trim tool, release the retaining clips.
- Instrument Panel Trim Pad (2) - Remove
- Disconnect the electrical connector.
Instrument Panel Center Trim Panel Bolt (1) - Remove [6x]
- Disconnect the electrical connectors.
- Instrument Panel Transmission Shift Opening Cover (2) - Remove
Electronic Transmission Shift Control Pushbutton Bolt (1) - Remove [3x]
- Electronic Transmission Shift Control Pushbutton (2) - Remove
NOTE:
Use care not to bend or deform the thin area of the instrument panel trim pad.