Removal Procedure
Automatic Transmission Fluid Filter (2) - Remove - Automatic Transmission Fluid, Fluid Pan and/or Filter Replacement (LM2)
Control Valve Upper Body Bolt (1) - Remove
- Automatic Transmission Auxiliary Fluid Pump Outlet Pipe (2) - Remove
- Automatic Transmission Auxiliary Fluid Pump Outlet Pipe Seal (3) - Remove and DISCARD
- Automatic Transmission Auxiliary Fluid Pump Seal (4) - Remove and DISCARD
Automatic Transmission Auxiliary Fluid Pump Bolt (1) - Remove [3x]
- Disconnect the electrical connector.
- Automatic Transmission Auxiliary Fluid Pump (2) - Remove
- NOTE:
The control valve solenoid body bolts are marked by arrows in the valve body casting.
Control Valve Solenoid Body Bolt (1) - Remove [2x]
- Control Valve Solenoid Body Bolt (2) - Remove and DISCARD [3x]
- Control Valve Solenoid Body Bolt (3) - Remove [2x]
Disconnect the park inhibitor solenoid electrical connector (1).
- Park Inhibitor Solenoid (2) - Remove
- Unlock the main control wiring harness connector latch (3).
- Disconnect the transmission wiring harness (4).
- Control Valve Body Assembly (5) - Remove
Automatic Transmission Fluid Pump Seal (1) - Remove and DISCARD
Automatic Transmission Intermediate Speed Sensor Bolt (1) - Remove
- Automatic Transmission Intermediate Speed Sensor (2) - Remove
NOTE:
Do not disassemble the control valve body assembly. The internal parts are NOT serviceable.