Removal Procedure

Raise and support the vehicle. Lifting and Jacking the Vehicle
Courtesy of GENERAL MOTORS COMPANY

Rear Propeller Shaft Bolt (1) - Remove [4x]
Courtesy of GENERAL MOTORS COMPANY

Propeller Shaft (1) - Remove
Support the transmission with a suitable jack.
Courtesy of GENERAL MOTORS COMPANY

Remove the wiring harness (2) from the 3 wiring harness retainers (1) and reposition the wiring harness as necessary.
If replacing the transmission support crossmember, transfer the 3 wiring harness retainers to the new transmission support crossmember.
Courtesy of GENERAL MOTORS COMPANY

Transmission Mount Nut (1) - Remove
Transmission Support Crossmember Nut (2) - Remove [4x]
Transmission Support Crossmember Bolt (3) - Remove [4x]
Courtesy of GENERAL MOTORS COMPANY

Transmission Support Crossmember (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Transmission Mount Bolt (1) - Remove [2x]
Transmission Mount (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Some components not shown for graphic clarity.

Remove the 2 wiring harness retainers (1).
Courtesy of GENERAL MOTORS COMPANY

Automatic Transmission Case Extension Bolt (1) - Remove [6x]
Automatic Transmission Case Extension (2) - Remove
Automatic Transmission Case Extension Seal (3) - Remove and DISCARD