LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2024 >> Tahoe Commercial, 4WD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 10L80 (MHS MHU MQC) - Diagnostic Information And Procedures (2 Of 2) >> Diagnostic Information and Procedures >> DTC P2820 or P2821 >> Circuit/System Verification

Circuit/System Verification

  1. Verify the condition does not exist: Incorrect fluid level or condition - Refer to: Transmission Fluid Level and Condition Check 
    • If a condition exists 

      Repair or replace as necessary

    • Go to next step: If no condition exists 
  2. Ignition - On/Vehicle - In Service Mode
  3. Perform the following action: Clear the DTCs.
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.Refer to: Road Test 

    Verify that no DTC listed in the DTC Descriptor Category is set.

    • If any DTC listed in the DTC Descriptor Category is set 

      Refer to: Diagnostic Fault Information & Verify the conditions listed in the table do not exist

    • Go to next step: If none of the DTCs listed in the DTC Descriptor Category is set 
  5. All OK.
scientia non olet · About LEMON Manuals