Conditions for Running the DTC

• DTC P2534 = Not set
• DTCs related to the following system/component = Not Set
  • B14A Automatic Transmission Output Speed Sensor
  • B14C Automatic Transmission Input Speed Sensor
  • B14DA Automatic Transmission Intermediate Speed Sensor 1
  • B14DB Automatic Transmission Intermediate Speed Sensor 2
  • B303 Transmission Range Sensor
  • Transmission Control Solenoid Valves - Circuit DTCs
• Battery Voltage = Greater than 9 V
• Engine = Running
• High Side Driver 1, 2 = On
• Ignition and Start Signal = 9 to 32 V
• Ignition and Start Switch Signal = On
• Scan Tool Control Function = Not Activated
• Transmission Range = D, L or M
• One of the following conditions listed below is true:
  • Accelerator Pedal Position = Greater than 0.5%
  • Engine Speed = Greater than 1, 000 RPM
  • Transmission Input Speed = Greater than 349 RPM
  • Transmission Output Shaft Speed = Greater than 35 RPM

Frequency the DTC runs = Continuously - After the running conditions are met