Conditions for Running the DTC

• Q77B Transmission Control Solenoid Valve 2 = Enabled
• Battery Voltage = Greater than 9 V
• Engine Speed = Greater than 499 RPM
• High Side Driver 1, 2 = On
• Ignition and Start Signal = 9 to 32 V
• Ignition and Start Switch Signal = On
• Input Shaft Speed Sensor = Greater than 300 RPM
• Transmission Fluid Temperature = Greater than 0°C (32°F)
• Transmission Service Fast Learn = Disabled

Frequency the DTC runs = Continuously - After the running conditions are met