Conditions for Running the DTC
P0741
- DTC P0746, P0747, P0776, P0777, P0796, P0797, P2714, P2715, P2723, P2724, P2732, P2733, P281B, P281D, P281E, P2820 = Not set
- DTCs related to the following system/component = Not Set
- B14A Automatic Transmission Output Speed Sensor
- B14C Automatic Transmission Input Speed Sensor
- B26 Crankshaft Position Sensor
- B65 Manifold Absolute Pressure and Intake Air Temperature Sensor
- B75 Mass Airflow Sensor
- B107 Accelerator Pedal Position Sensor
- Q17 Fuel Injector
- Engine Misfire
- Fuel Trim System
- Accelerator Pedal Position Sensor = 0 to 100%
- Battery Voltage = Greater than 9 V
- Engine Speed = Greater than 499 RPM
- Engine Torque = Greater than 4 Nm (3 lb ft)
- Ignition and Start Signal = 9 to 32 V
- Ignition and Start Switch Signal = On
- Transmission Fluid Temperature = -6 to 130°C (21 to 266°F)
- Transmission Range = P, N
Frequency the DTC runs = Continuously - After the running conditions are met
P2817
- DTC P281B, P281D, P281E = Not set
- DTCs related to the following system/component = Not Set
- B14A Automatic Transmission Output Speed Sensor
- B14C Automatic Transmission Input Speed Sensor
- B26 Crankshaft Position Sensor
- B65 Manifold Absolute Pressure and Intake Air Temperature Sensor
- B75 Mass Airflow Sensor
- B107 Accelerator Pedal Position Sensor
- Q17 Fuel Injector
- Engine Misfire
- Fuel Trim System
- Accelerator Pedal Position Sensor = 8 to 99%
- Battery Voltage = Greater than 9 V
- Engine Speed = Greater than 499 RPM
- Engine Torque = Greater than 50 Nm (47 lb ft)
- Ignition and Start Signal = 9 to 32 V
- Ignition and Start Switch Signal = On
- Transmission Control Solenoid Valve 8 = On
- Transmission Fluid Temperature = -6 to 130°C (21 to 266°F)
Frequency the DTC runs = Continuously - After the running conditions are met
P2818
- DTC P0746, P0747, P0776, P0777, P0796, P0797, P2714, P2715, P2723, P2724, P2732, P2733, P281B, P281D, P281E, P2820 = Not set
- DTCs related to the following system/component = Not Set
- B14A Automatic Transmission Output Speed Sensor
- B14C Automatic Transmission Input Speed Sensor
- B26 Crankshaft Position Sensor
- B65 Manifold Absolute Pressure and Intake Air Temperature Sensor
- B75 Mass Airflow Sensor
- B107 Accelerator Pedal Position Sensor
- Q17 Fuel Injector
- Engine Misfire
- Fuel Trim System
- 4WD Low = Disengaged
- Accelerator Pedal Position Sensor = Less than 6%
- Battery Voltage = Greater than 9 V
- Engine Speed = 200 to 600 RPM
- Engine Torque = -25 to 800 Nm (-18 to 590 lb ft)
- Ignition and Start Signal = 9 to 32 V
- Ignition and Start Switch Signal = On
- Transmission Control Solenoid Valve 8 = Off
- Transmission Range = P, N
- Transmission Fluid Temperature = -6 to 130°C (21 to 266°F)
- Vehicle Speed = Less than 4 km/h (3 MPH)
Frequency the DTC runs = Continuously - After the running conditions are met