Conditions for Running the DTC

P0716

• DTC P0717, P07BF, P07C0 = Not set
• DTCs related to the following system/component = Not Set
  • B75 Mass Airflow Sensor
  • B107 Accelerator Pedal Position Sensor
  • Q14 Exhaust Gas Recirculation Valve
  • Q17 Fuel Injector
  • Engine Misfire
  • Fuel Trim System
• Accelerator Pedal Position Sensor = Greater than 4%
• Battery Voltage = Greater than 9 V
• Engine Torque = Greater than 30 Nm (22 lb ft)
• High Side Driver 1, 2 = On
• Ignition and Start Signal = 9 to 32 V
• Ignition and Start Switch Signal = On
• Output Shaft Speed Sensor = Greater than 239 RPM
• Transmission Service Fast Learn = Disabled

Frequency the DTC runs = Continuously - After the running conditions are met

P0717

• DTC P0716, P07BF, P07C0 = Not set
• DTCs related to the following system/component = Not Set
  • B14A Automatic Transmission Output Speed Sensor
  • B65 Manifold Absolute Pressure and Intake Air Temperature Sensor
  • B75 Mass Airflow Sensor
  • B107 Accelerator Pedal Position Sensor
  • Q14 Exhaust Gas Recirculation Valve
  • Q17 Fuel Injector
  • Engine Misfire
  • Fuel Trim System
• Accelerator Pedal Position Sensor = Greater than 4%
• Battery Voltage = Greater than 9 V
• Brake Pedal Position = Less than 70%
• Engine Torque = Greater than 30 Nm (22 lb ft)
• Ignition and Start Signal = 9 to 32 V
• Ignition and Start Switch Signal = On
• Output Shaft Speed Sensor = Greater than a predefined threshold
• Transmission Service Fast Learn = Disabled

Frequency the DTC runs = Continuously - After the running conditions are met

P07BF, P07C0

• {P07BF} DTC P07C0 = Not set
• {P07C0} DTC P07BF = Not set
• Battery Voltage = Greater than 10 V
• Ignition and Start Signal = 9 to 32 V
• Ignition and Start Switch Signal = On
• Transmission Service Fast Learn = Disabled

Frequency the DTC runs = Continuously - After the running conditions are met

P1783

• Battery Voltage = Greater than 9 V
• Engine Speed = Greater than 499 RPM
• Ignition and Start Signal = 9 to 32 V
• Ignition and Start Switch Signal = On
• Transmission Service Fast Learn = Disabled

Frequency the DTC runs = Continuously - After the running conditions are met

P17CE

• Battery Voltage = Greater than 9 V
• Ignition and Start Signal = 9 to 32 V
• Ignition and Start Switch Signal = On
• Input Shaft Speed Sensor = Greater than 224 RPM

Frequency the DTC runs = Continuously - After the running conditions are met