Component Testing
- Ignition/Vehicle - Off
- Remove the component: Automatic Transmission Fluid Pan
- Remove the component: Control Valve Assembly
- Disconnect the electrical connector: B13 Automatic Transmission Fluid Temperature Sensor
- Test for 20 to 200, 000 ohms between the test points: Signal terminal 2 & Low Reference terminal 1
- If not between 20 and 200, 000 ohms
Replace the component: B13 Automatic Transmission Fluid Temperature Sensor
- Go to next step: If between 20 and 200, 000 ohms
- If not between 20 and 200, 000 ohms
- Verify the value is within the range listed in the table: Temperature Versus Resistance - B13 Automatic Transmission Fluid Temperature Sensor
- If not in the specified range
Replace the component: B13 Automatic Transmission Fluid Temperature Sensor
- Go to next step: If in the specified range
- If not in the specified range
- All OK.