Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Ignition - On/Vehicle - In Service Mode
Verify there are no DTCs set related to the following component/system: KR75 Engine Controls Ignition Relay
- If a related DTC is set
  Refer to: DTC P0685-P0687, P0689, P0690, P1682, P16BC, P16BD, or P16BF
- Go to next step: If a related DTC is not set
Engine - Cranking - For 10 s
Verify the function: Engine = Running
- If the function does not work
  Refer to: Circuit/System Testing
- Go to next step: If the function works
Verify a condition does not exist with the component: Engine - The engine should not stumble/stall.
Perform the action while monitoring the component:
- Wiggle the harness and connector(s): K20 Engine Control Module
- Wiggle the harness and connector(s): X50A Fuse Block - Underhood
- If a condition exists
  Repair as necessary - Wiring/Terminal(s)/Electrical Connector(s)
- Go to next step: If no condition exists
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
  Refer to: Circuit/System Testing
- Go to next step: If the DTC is not set
All OK.