Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Verify there are no DTCs set related to the following component/system:
- B9 Ambient Air Temperature Sensor
- B14A Automatic Transmission Output Speed Sensor
- B26 Crankshaft Position Sensor
- B34 Engine Coolant Temperature Sensor
- B65 Manifold Absolute Pressure and Intake Air Temperature Sensor
- B75 Mass Airflow Sensor
- B107 Accelerator Pedal Position Sensor
- Fuel System
- If a related DTC is set
  Refer to: Diagnostic Trouble Code (DTC) List - Vehicle
- Go to next step: If a related DTC is not set
Verify the condition does not exist:
- Aftermarket equipment/accessories: Performance Components - Installed
- Accessory drive belt component - Worn/Failed
- Engine Oil - Overfull
- Fuel - Contamination Refer to: Contaminants-in-Fuel Diagnosis
- Torque Converter - Failed/Worn
- If a condition exists
  Repair or replace as necessary
- Go to next step: If no condition exists
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
  Refer to: Circuit/System Testing
- Go to next step: If the DTC does not set
All OK.