Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
P0475, P0478
Control Circuit = Commanded state does not match the actual state - For greater than 4 s
P10C0
Control Circuit - Terminal 4 & 5 = Short between the circuits - For greater than 4 s
P10EB
Control module K20 detects: High Current@Control Circuit - For greater than 4 s
P2B98
Exhaust Pressure Regulator Valve = Supply Voltage Circuit Low Voltage - For greater than 4 s
P2B99
Motor Temperature@Exhaust Pressure Regulator Valve = High Temperature - For greater than 4 s