Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Ignition - On/Vehicle - In Service Mode
Verify DTC P02E8, P02E9, U0654 is not set.
- If any of the DTCs are set
  Refer to: DTC P02E8, P02E9, or U0654
- Go to next step: If none of the DTCs are set
Engine at Idle Verify the scan tool parameter:
- Intake Air Flow Control Valve Control Circuit High Test Status = Not Run or Okay
- Intake Air Flow Control Valve Control Circuit Low Test Status = Not Run or Okay
- Intake Air Flow Control Valve Control Circuit Open Test Status = Not Run or Okay
- Intake Air Flow Control Valve Control Circuit Shorted Test Status = Not Run or Okay
- If not the specified state
  Refer to: Circuit/System Testing
- Go to next step: If the specified state
Clear the DTCs.
Ignition Off - For greater than 1 min
Ignition - On/Vehicle - In Service Mode
Verify DTC P02E1, P02E5 is not set.
- If the DTC sets
  Refer to: Circuit/System Testing
- Go to next step: If the DTC does not set
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
  Refer to: Circuit/System Testing
- Go to next step: If the DTC does not set
All OK.