Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Ignition - On/Vehicle - In Service Mode
Verify DTC P003A, P0045 - P0048, P0071 - P0074, P00C7, P0106 - P0108, P0116 - P0119, P0128, P02E1, P02E8, P02E9, P111E, P122D, P169E, P169F, P16FA, P16FC, P2227 - P2230, U0654, U0656 is not set.
- If any of the DTCs are set
  Refer to: Diagnostic Trouble Code (DTC) List - Vehicle
- Go to next step: If none of the DTCs are set
Verify the scan tool parameter: MAP Sensor = The value should be within the range listed in the table: Altitude Versus Barometric Pressure
- If not in the specified range
  Refer to: DTC P0106, P0107, or P0108
- Go to next step: If in the specified range
Engine - Idling - At normal operating temperature.
Verify the scan tool parameter: MAP Sensor = The value should change with accelerator pedal input.
- If the value does not change
  Refer to: DTC P0106, P0107, or P0108
- Go to next step: If the value changes
Perform the scan tool control function: Turbocharger Vane Position - Increase & Decrease
Verify the scan tool parameter: Turbocharger Vane Position Sensor = Desired Turbocharger Vane Position
- If not the specified state
  Refer to: Circuit/System Testing
- Go to next step: If the specified state
Verify the scan tool parameter: Induction System Leak Indication = 0.75: 1 to 1.25: 1 - Stable
- If not in the specified range
  Refer to: Circuit/System Testing
- Go to next step: If in the specified range
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
  Refer to: Circuit/System Testing
- Go to next step: If the DTC does not set
All OK.