Component Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition/Vehicle - Off
- Disconnect the appropriate electrical connector: Q18 Fuel Pressure Regulator
- Test for 0.3 to 2.0 ohms between the test points: Component terminal 1 & Component terminal 2
- If not between 0.3 and 2.0 ohms
Replace the component: Q18 Fuel Pressure Regulator
- Go to next step: If between 0.3 and 2.0 ohms
- If not between 0.3 and 2.0 ohms
- Test for infinite resistance between the test points: Each terminal of the component & The component's housing
- If less than infinite resistance
Replace the component: Q18 Fuel Pressure Regulator
- Go to next step: If infinite resistance
- If less than infinite resistance
- All OK.
NOTE:
The specified resistances are valid for components at room temperature.