Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Throttle Body Gasket (3) - Install NEW
- Throttle Body (2) - Install
- Throttle Body Bolt (1) - Install and tighten [3x] - Fastener Specifications
- Connect the throttle body electrical connector.
Charge Air Cooler Outlet Air Hose (2) - Install
- Charge Air Cooler Outlet Air Hose Clamp (1) - Tighten [2x] - Fastener Specifications
- Oil Filler Cap - Remove
Intake Manifold Cover (2) - Install
- Intake Manifold Cover Bolt (1) - Install and tighten - Fastener Specifications
- Oil Filler Cap - Install
CAUTION:
Refer to Fastener Caution .