Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- CAUTION:
Refer to Component Fastener Tightening Caution .
Nitrogen Oxides Sensor (1) - Install and tighten - Fastener Specifications
Connect the electrical connector (2)
- Nitrogen Oxides Sensor Control Module Bracket Bolt (1) - Install and tighten [2x] - Fastener Specifications
Engage the nitrogen oxides sensor wiring harness clips (1).
- Lower the vehicle.
- Perform the following reset procedure. Nitrogen Oxides Catalytic Converter Reductant Loading Reset
CAUTION:
Refer to Fastener Caution .