Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- CAUTION:
Refer to Component Fastener Tightening Caution .
Nitrogen Oxides Sensor (1) - Install and tighten - Fastener Specifications
Connect the electrical connector (3).
- Nitrogen Oxides Sensor Nut (2) - Install and tighten [2x] - Fastener Specifications
- Engage the nitrogen oxides sensor wiring harness clips (1).
- Remove the support and lower the vehicle.
- Perform the nitrogen oxides catalytic converter reductant loading reset. Nitrogen Oxides Catalytic Converter Reductant Loading Reset
CAUTION:
Refer to Fastener Caution .