Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Raise and support the vehicle. Lifting and Jacking the Vehicle
Disconnect the fuel pump power control module electrical connector (1).
- Disengage the wiring harness retainer (2).
- Fuel Pump Power Control Module Bracket Bolt (3) - Loosen [2x]
- Fuel Pump Power Control Module Bracket (4) - Remove
Fuel Pump Power Control Module Nut (1) - Remove [2x]
- Fuel Pump Power Control Module (2) @Fuel Pump Power Control Module Bracket (3) - Remove
NOTE:
Slide the fuel pump power control module bracket up and out of the groves in the frame to remove.