Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Fuel Pump Power Control Module (2) @Fuel Pump Power Control Module Bracket (3) - Install
- Fuel Pump Power Control Module Nut (1) - Install and tighten [2x] - Fastener Specifications
- NOTE:
Slide the fuel pump power control module bracket down and into the groves in the frame to install.
Fuel Pump Power Control Module Bracket (4) - Install
- Fuel Pump Power Control Module Bracket Bolt (3) - Tighten [2x] - Fastener Specifications
- Engage the wiring harness retainer (2).
- Connect the fuel pump power control module electrical connector (1).
- Lower the vehicle.
CAUTION:
Refer to Fastener Caution .