Removal Procedure
- Turn OFF the engine for 30 seconds before proceeding to purge the fuel pressure from the complete fuel system.
- Front Wheelhouse Liner-Left Side - Remove - Front Wheelhouse Liner Replacement
- Disconnect all wiring harness retainers from the fuel feed and fuel return pipe.
Fuel Feed Pipe (1) - Disconnect - Metal Collar Quick Connect Fitting Service
- Fuel Return Pipe (2) - Disconnect - Metal Collar Quick Connect Fitting Service
{If equipped} Transfer Case Skid Shield Bolt (1) - Remove [3x]
- {If equipped} Transfer Case Skid Shield (2) - Remove
{with F47} Unclip the 2 air line retainers (1) and reposition the air line (2).
{with F47} Remove the chassis wire harness clip (1) from the automatic level control air supply reservoir.
{with F47} Remove the 3 automatic level control air compressor bolts (1).
- {with F47} Reposition and support the automatic level control air supply reservoir (2) out of the way of the transmission support crossmember.
{If equipped} Remove the 3 wiring harness retainers (1) from the transmission support crossmember, and reposition the wiring harness (2) as necessary.
- Support the transmission with a suitable jack.
Transmission Mount Nut (1) - Remove [2X]
- Transmission Support Crossmember Nut (2) - Remove [4x]
- Transmission Support Crossmember Bolt (3) - Remove [4x]
Transmission Support Crossmember (1) - Remove
- Lower the transmission to gain access to the top and sides of the transmission.
Mark a reference point between the front axle propeller shaft (1) and the front differential drive pinion gear yoke.
- Front Axle Propeller Shaft Bolt (2) - Remove [6x]
- Front Axle Propeller Shaft Washer (3) - Remove [3x]
- Front Axle Propeller Shaft (1) - Reposition away
Hose Clamp (1) - Disengage [2x] - Hose Clamp Replacement Guidelines - Spring Type
- Fuel Cooler Coolant Cooler Inlet Hose (2) - Remove and position aside [2x]
Fuel Feed and Return Front Hose Bracket Nut (1) - Remove
- Fuel Feed and Return Pipe (2) - Remove
Fuel Return Pipe (1) - Disconnect - Metal Collar Quick Connect Fitting Service
- Tie Strap (2) - Remove and DISCARD
- Fuel Feed and Return Pipe (4) @Retainer (3) - Disengage
- {If equipped} Remove the transfer case vent hose retainers.
Fuel Feed and Return Pipe (1) - Disconnect - Plastic Collar Quick Connect Fitting Service
- Fuel Feed and Return Pipe (1) @Retainer (2) - Disengage
- Fuel Feed and Return Pipe (1) - Remove
Fuel Feed Pipe (1) @Retainer (2) - Disengage [2x]
- Fuel Feed Pipe (1) - Remove