Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Drain the cooling system. Cooling System Draining and Filling (Static LM2) , or Cooling System Draining and Filling (GE 47716 LM2)
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Front Wheelhouse Liner-Right Side (3) - Remove - Front Wheelhouse Liner Replacement
Courtesy of GENERAL MOTORS COMPANY

{With Z45} Disconnect the front suspension 4-corner leveling system position sensor link (2) from the electronic suspension front position sensor link ball stud (1).
Disconnect the electrical connector.
{With Z45} Loosen the front suspension 4-corner leveling system position sensor (3).
{With Z45} Remove the front suspension 4-corner leveling system position sensor (3) from the keyhole slot at the frame.
Courtesy of GENERAL MOTORS COMPANY

Radiator Outlet Hose Clamp (1) - Disengage - Hose Clamp Replacement Guidelines - Spring Type
Radiator Outlet Hose (2) @Engine Radiator - Remove
Courtesy of GENERAL MOTORS COMPANY

Radiator Outlet Hose Clamp (1) - Disengage - Hose Clamp Replacement Guidelines - Spring Type
Radiator Outlet Hose (2) @Water Pump Inlet Pipe - Remove
Courtesy of GENERAL MOTORS COMPANY

Disconnect the electrical connector.
Engine Coolant Temperature Sensor (1) - Remove