Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- CAUTION:
Refer to Component Fastener Tightening Caution .
Engine Coolant Temperature Sensor (1) - Install and tighten - Fastener Specifications
- Connect the electrical connector.
Radiator Outlet Hose (2) @Water Pump Inlet Pipe - Install
- Radiator Outlet Hose Clamp (1) - Engage - Hose Clamp Replacement Guidelines - Spring Type
Radiator Outlet Hose (2) @Engine Radiator - Install
- Radiator Outlet Hose Clamp (1) - Engage - Hose Clamp Replacement Guidelines - Spring Type
{With Z45} Insert the front suspension 4-corner leveling system position sensor (3) into the keyhole slot at the frame.
- {With Z45} Install and tighten the front suspension 4-corner leveling system position sensor (3). Fastener Specifications
- Connect the electrical connector.
- {With Z45} Connect the front suspension 4-corner leveling system position sensor link (2) to the electronic suspension front position sensor link ball stud (1).
Front Wheelhouse Liner-Right Side (3) - Install - Front Wheelhouse Liner Replacement
- Perform the electronic suspension position sensor trim height calibration. Automatic Level Control Trim Height Learn
- Fill the cooling system to the proper level. Cooling System Draining and Filling (Static LM2) , or Cooling System Draining and Filling (GE 47716 LM2)
- Start the engine and check for coolant leaks.
CAUTION:
Refer to Fastener Caution .