Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Engine Control Module (2) - Install
Connect the 2 electrical connectors (1) to the engine control module.
Front Wheelhouse Liner (1) - Install
Front Wheelhouse Liner Retainer (2) - Install
- Front Wheelhouse Liner Bolt (1) - Install and tighten [3x] - Fastener Specifications
Front Wheelhouse Liner Bolt (1) - Install and tighten [3x] - Fastener Specifications
{If equipped} Front Tire Front Air Deflector Bolt (1) - Install and tighten - Fastener Specifications
- Install the front tire and wheel assembly. Tire and Wheel Removal and Installation (Steel Wheel) , or Tire and Wheel Removal and Installation (Aluminum Wheel)
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (9C1/5W4) , or Battery Negative Cable Disconnection and Connection (KL9)
- It is necessary to reprogram the module. Control Module References
- It is necessary to perform the turbocharger/supercharger boost control initial position learn. Turbocharger/Supercharger Boost Control Initial Position Learn
- Use the scan tool to reset the engine oil life remaining back to the original percentage recorded.