LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2024 >> Tahoe Commercial, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Controls And Fuel - 3.0L (Lm2) Diesel - Repair Instructions (1 Of 2)) >> Repair Instructions >> Engine Control Module Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM5535969Courtesy of GENERAL MOTORS COMPANY

    Transmission Control Module (3) - Install

  2. Engine Control Module Bracket (2) - Install
    3. CAUTION:

    Refer to Fastener Caution .

  3. Engine Control Module Bracket Bolt (1) - Install and tighten [3x] - Fastener Specifications
  4. Install harness retainers as needed.
  5. GM5535962Courtesy of GENERAL MOTORS COMPANY

    Connect the electrical connector. (1)

  6. GM5150259Courtesy of GENERAL MOTORS COMPANY

    Engine Control Module (1) - Install

  7. Connect the electrical connectors.
  8. GM5629452Courtesy of GENERAL MOTORS COMPANY

    Front Wheelhouse Liner (3) - Install

  9. Front Wheelhouse Liner Retainer (2) - Install
  10. Front Wheelhouse Liner Bolt (1) - Install and tighten [6x] - Fastener Specifications
  11. GM5522093Courtesy of GENERAL MOTORS COMPANY

    {If equipped} Front Tire Front Air Deflector Bolt (1) - Install and tighten - Fastener Specifications

  12. Install the left front tire and wheel assembly. Tire and Wheel Removal and Installation (Steel Wheel) , or Tire and Wheel Removal and Installation (Aluminum Wheel)
  13. Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (9C1/5W4) , or Battery Negative Cable Disconnection and Connection (KL9)
scientia non olet · About LEMON Manuals