Cleaning and Inspection Procedure - Required
WARNING: This page is about a different variant/trim than selected.
CAUTION:
The glow plug bore MUST be cleaned prior to glow plug installation. If the glow plug bore is not cleaned of carbon buildup prior to glow plug installation, it may cause severe damage to the glow plug. If the glow plug is damaged, the glow plug bore and combustion chamber must be cleaned of all debris, and the glow plug must be replaced.
Using the EN-52074 Glow Plug Bore Reamer (1), clean the glow plug bore. Hole must be free of lubricant and grease.