Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Plenum Front Panel Outer Reinforcement (1) - Remove - Plenum Front Panel Outer Reinforcement Replacement
Courtesy of GENERAL MOTORS COMPANY

Engine Wiring Harness Bracket Nut (1) - Remove [3x]
Engine Wiring Harness Channel (2) Reposition
Courtesy of GENERAL MOTORS COMPANY

Disconnect the electrical connector.
Disconnect the engine wiring harness retainer from the exhaust pressure differential sensor bracket.
Exhaust Pressure Differential Sensor Bracket Nut (1) - Remove
Exhaust Pressure Differential Sensor - Reposition
Courtesy of GENERAL MOTORS COMPANY

Exhaust Pressure Differential Sensor Bracket Stud (1) - Remove [2x]
Exhaust Pressure Differential Sensor Bracket (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Exhaust Pressure Sensor Hose Clamp (1) @Exhaust Pressure Differential Sensor Pipe - Disengage - Hose Clamp Replacement Guidelines - Spring Type
Courtesy of GENERAL MOTORS COMPANY

Exhaust Pressure Sensor Hose Clamp (1) @Exhaust Pressure Sensor Pipe (2) - Disengage - Hose Clamp Replacement Guidelines - Spring Type
Courtesy of GENERAL MOTORS COMPANY

Exhaust Pressure Sensor Pipe (1) - Remove