Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Oil Filler Cap - Remove
Courtesy of GENERAL MOTORS COMPANY

Intake Manifold Cover Bolt (1) - Remove
Intake Manifold Cover (2) - Remove
Install the oil filler cap after removal of the intake manifold cover (2) to prevent debris from falling into the engine.
Courtesy of GENERAL MOTORS COMPANY

Engine Wiring Harness Bracket Nut (1) - Remove [2x]
Engine Wiring Harness Bracket Bolt (2) - Remove
Engine Wiring Harness Bracket (3) - Reposition
Courtesy of GENERAL MOTORS COMPANY

Disconnect the cylinder head temperature sensor electrical connector (1).
Courtesy of GENERAL MOTORS COMPANY

Cylinder Head Temperature Sensor (1) - Remove