Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Crankshaft Position Sensor (1) - Install
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Crankshaft Position Sensor Bolt (1) - Install and tighten - Fastener Specifications
Connect the crankshaft position sensor electrical connector.
Courtesy of GENERAL MOTORS COMPANY

Starter Heat Shield (1) - Install
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Components removed for graphic clarity.

Engage the starter heat shield (2) into the retainer (1).
Starter Heat Shield Bolt (3) - Install and tighten [2x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Chassis Wiring Harness Front Bracket (4) - Install
Install the positive battery cable retainers to the chassis wiring harness front bracket.
Chassis Wiring Harness Front Bracket Front Bolt (3) - Install and tighten - Fastener Specifications
Chassis Wiring Harness Front Bracket Retainer (2) - Install [2x]
Chassis Wiring Harness Front Bracket Rear Bolt (1) - Install and tighten - Fastener Specifications
Front Wheelhouse Liner-Right Side - Install - Front Wheelhouse Liner Replacement
Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (9C1/5W4) , or Battery Negative Cable Disconnection and Connection (KL9)
Perform the crankshaft position variation learn. Crankshaft Position Variation Learn