Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Mass Airflow Sensor (2) - Install
Mass Airflow Sensor Bolt (1) - Install and tighten [2x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Air Cleaner Lower Housing (1) - Install
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Air Cleaner Nut (1) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Accessory Wiring Junction Block (2) - Install
Engine Wiring Harness Fuse Block Bracket Bolt (1) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Electrical Connector (1) @Air Cleaner Lower Housing - Install
Install all retainers to the air cleaner lower housing.
Courtesy of GENERAL MOTORS COMPANY

Air Cleaner Upper Housing (2) - Install
Air Cleaner Housing Cover Bolt (1) - Install and tighten [3x] - Fastener Specifications
Connect the mass airflow sensor electrical connector.
Courtesy of GENERAL MOTORS COMPANY

Intake Air Duct (2) - Install
Intake Air Duct Retainer (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Intake Air Splash Shield (2) - Install
Intake Air Baffle Retainer (1) - Install [9x]
Courtesy of GENERAL MOTORS COMPANY

Hood Secondary Latch Release Handle (2) - Install
Hood Latch Actuator Bolt (1) - Install and tighten [2x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Air Cleaner Outlet Front Duct (2) - Install
Air Cleaner Outlet Duct Clamp (1) - Tighten [2x] - Fastener Specifications