Crankshaft Bearing Cap Bolt Tightening Sequence
WARNING: This page is about a different variant/trim than selected.
| Crankshaft Bearing Cap Bolt Tightening Sequence | |||||
|---|---|---|---|---|---|
| Callout | Component Name [Component Quantity] | Single Use Fastener/Component | Thread Locking Adhesive Required | Specification | Procedure |
| Metric (English) | |||||
| 1 | Crankshaft Bearing Cap Bolt [14x] | - | - | First Pass: 25 N.m (18 lb ft) Second Pass: 35 N.m (26 lb ft) Third Pass: Using EN-45059 - A Angle Meter, tighten all bolts in sequence 90 degrees Final Pass: Using EN-45059 - A Angle Meter, tighten all bolts in sequence 90 degrees |
Crankshaft and Bearing Removal and Installation |