Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Oil Level Indicator Seal (2) @Oil Level Indicator Tube - Install NEW
Courtesy of GENERAL MOTORS COMPANY

NOTE:
With aid of assistant reposition the engine wiring harness and note the routing of oil level indicator tube.

Oil Level Indicator Tube (2) - Install

CAUTION:

Oil Level Indicator Tube Bolt (1) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Engine Oil Level Indicator (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Air Cleaner Outlet Front Duct (2) - Install
Air Cleaner Outlet Duct Clamp (1) - Tighten [2x] - Fastener Specifications
Raise the vehicle.
Courtesy of GENERAL MOTORS COMPANY

Exhaust Gas Recirculation Coolant Return Pipe (2) - Install
Thermostat Bypass Pipe Bolt (3) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Clip (2) @Oil Level Indicator Tube - Install
Oil Level Indicator Tube Stud (1) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Thermostat Bypass Hose (1) - Install
Engine Coolant Air Bleed Hose Stud (2) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Engine Wiring Harness Bracket (2) - Install
Engine Wiring Harness Bracket Nut (1) - Install and tighten [2x] - Fastener Specifications
Front Wheelhouse Liner-Left Side - Install - Front Wheelhouse Liner Replacement