Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- NOTE:
- Ensure that the sealing surface is clear of oil, grease and old sealant material.
- Ensure proper use of room temperature vulcanizing (RTV) sealant. Use of Room Temperature Vulcanizing (RTV) and Anaerobic Sealant
- The bolts must be installed and fastened to final torque specification immediately after the component is installed.
Apply a 4.0 mm (0.158 in) bead of sealer (1) to the oil pan sealing surface. Adhesives, Fluids, Lubricants, and Sealers
- NOTE:
Ensure the alignment pins are properly aligned when installing the oil pan.
Lower Oil Pan (1) - Install NEW
Oil Pan Bolt (1) - Install and hand tighten [23x]
- Oil Pan Bolt (1) - Tighten in sequence [23x] - Fastener Specifications
Drivetrain and Front Suspension Frame Front Crossmember (1) - Install
Drivetrain and Front Suspension Frame Reinforcement Bolt (2) - Install [4x]
- Drivetrain and Front Suspension Frame Reinforcement Nut (1) - Install [4x]
- Using the EN-45059 - A Angle Meter, tighten the 4 drivetrain and front suspension frame reinforcement nuts (1). Fastener Specifications
Underbody Skid Shield (1) - Install
- Underbody Skid Shield Bolt (2) - Install and tighten [4x] - Fastener Specifications
- Lower the vehicle.
- Fill the engine oil to the proper level with NEW engine oil. Engine Oil and Oil Filter Replacement
CAUTION:
Refer to Fastener Caution .