Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Engine - Running
- Verify there are no DTCs set related to the following component/system: Engine Controls and Fuel
- If any DTC is set
- Go to next step: If no DTC is set
- Verify the component works as specified: Malfunction Indicator Lamp (MIL) = Off
- If the component does not work as specified
Replace the component: P16 Instrument Cluster
- Go to next step: If the component works as specified
- If the component does not work as specified
- Ignition - On/Vehicle - In Service Mode
Verify the component works as specified: Malfunction Indicator Lamp (MIL) = On
- If the component does not work as specified
Replace the component: P16 Instrument Cluster
- Go to next step: If the component works as specified
- If the component does not work as specified
- All OK.