Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Ignition - On/Vehicle - In Service Mode
Verify DTC P0627, P0628, P0629, P1029, P102A, P102B, P1255, P12A6, P16D7, P16D8, U18A2 is not set.
- If any of the DTCs are set
  Refer to: Diagnostic Trouble Code (DTC) List - Vehicle .
- Go to next step: If none of the DTCs are set
Perform the scan tool function: Clear DTCs
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify DTC P129F is not set and no other DTCs are set.
- If any other DTCs are set
  Refer to: Diagnostic Trouble Code (DTC) List - Vehicle .
- If only DTC P129F is set
  Refer to: Circuit/System Testing
- Go to next step: If no DTC is set
All OK.